62-65 B Body
62-65 Bench Seat Back Stop
Used as a stop on all early B-body bench seats to keep seats in proper pos.
62-65 Radiator Shroud Clip Set - 1 Hole & 1 Slot
Correct reproductions of the original shroud clips P/N: 2099555. These are
Inner Door Rod Sleeving
Material used on all Chrysler products. Appearance as original, made of cot
Lower Control Arm Bump Stop Spacer
The lower control arm bump stop spacer was used in 1966 & 70 B-bodies with
2-4 Inline Phenolic Carb Spacer
2-4 inline phenolic carb spacer used on all 2-4 inline setups with AFB carb
Seat Track Return Spring
Seat track return spring used from 1962 to 1969 on all Mopars. Used when ad
3 inch Header Collector Gasket
Eliminate that annoying ticking sound from your header collector! This head
RB Motor M1 Intake Throttle Cable Bracket (kit)
Using an M1 intake on your RB engine, you need this throttle cable bracket.
Seat Track Adjuster Handle Springs (sold in pack o
Seat track adjuster handle springs are used for the handle on the side of t
Steering Column Upper Bearing
Replace your old worn out bearing with this new unit that is a sealed beari
2-4 Inline B/RB Engine Bracket Set Non A/C
Sets include all brackets needed to install a 2-4 inline setup
2-4 Inline B/RB Engine Bracket Set for A/C
Sets include all brackets needed to install a 2-4 inline setup
2-4 Inline B/RB Fuel Line Set 5 pc Original Mat'l
B/RB 2-4 Inline Fuel Line Set 5 pieces - Original Material
2-4 Inline B/RB Fuel Line Set 5 pc SS Mat'l
B/RB 2-4 Inline Fuel Line Set 5 pieces - Stainless Material
2-4 Inline B/RB Inlet Fitting 1/8" NPT
2-4 Inline B/RB Engine Carb Inlet Fitting 1/8" FNPT w/red washer
Wiper Pivot Felt Washer Set (1954-67 All cars)
Replace the worn out & thin wiper pivot washers with these fresh pieces
